Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9.1
Installation of the detector
(See illustrations 5 and 6)
1.
Select the installation location.
2.
Remove the mounting fixture from the unit by turning it anti-clockwise.
3.
Remove the locking pin (see illustration 5).
4.
Use the fixture for labelling the mounting openings.
5.
Use suitable mounting material for attaching the mounting fixture to the labelled position. If in
doubt, consult an expert before installing.
Warning
6.
Configure the detector as described in chapter 9.2.
7.
Align the side marking of the mounting fixture with the detector. Set the detector on the
mounting fixture and turn it clockwise in order to mount it at the correct point. (See
illustrations 5 A and B)
8.
Slide in the locking pin to lock the mounting fixture onto the detector (see illustration 5 C).
9.
Make sure that the detector is firmly connected to the mounting fixture.
10.
After you re-mount the detector on its base, you must check the smoke alarm. To do this,
conduct a functional test as described in the Testing section of these instructions.
When marking out the drill holes, make sure there are no electrical wires or
cables, pipes or other important components behind them. If in doubt, consult
an expert before drilling.
- 32 -
EN
Publicité
Table des Matières
