Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
R
ALED SLIPFITTER 50W 78W 105W 125W 150W INSTRUCTIONS
Thank you for buying RC lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-722-1000 or email: marketing@rclighting.ca
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
Make certain power is OFF before installing or maintaining fixture. No user serviceable parts
WARNING:
inside.
MOUNTING FIXTURE
1. The Slipfitter fits a 2 3 /8" O.D. Tenon. Place the slipfitter
over the tenon and secure the fixture with 2 Set Screws
on the side of the slipfitter.
2. Feed wires from Fixture through slipfitter and supply
wires from Pole. Make the necessary connections in the
slipfitter and knot wires for strain relief.
3. To adjust the angle of the slipfitter, remove 2 screws and
remove the Slipfitter Cover Plate. Loosen the Locking
Bolt and swivel fixture to desired angle. The graduation
on the slipfitter cover plate can be used as guidelines to
adjust the angle.
4. Tighten the Locking Bolt. Replace slipfitter cover plate.
Tighten Screws and close the Plug.
5. Seal Plug using Teflon tape or silicone sealant.
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1. Clean glass lens with non-abrasive glass cleaning
solution.
2. Do not open fixture to clean the LED. Do not touch the
LED.
ALEDSF-IN 0114 RCL
Plug
Slipfitter
cover plate
Screws
TROUBLESHOOTING
1.
Check that the line voltage at fixture is correct. Refer to
wiring directions.
2.
Is the fixture grounded properly?
3.
Is the photocell functioning properly (if used)?
Fixture
Slipfitter
Locking
Bolt
Tenon
Set
screws
Publicité
Table des Matières
