Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ALED SLIPFITTER 260W 360W INSTRUCTIONS
®
Thank you for buying RC lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-722-1000 or email: marketing@rclighting.ca
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RC fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. This product must be installed in accordance with the applicable installation code by a person familiar with the
construction and operation of the product and the hazards involved.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
CAUTION: The fixture weighs 80lbs. Make sure pole and hardware supplied by others (if any) can withstand the weight of
the fixture.
MOUNTING FIXTURE
1. The Slipfitter fits a 2 3 /8" O.D. Tenon. Place the slipfitter
over the Tenon and secure the fixture with Set Screws
(2) on the side of the Slipfitter.
2. Feed wires from Fixture through Slipfitter and supply
wires from pole (not supplied). Make the necessary
connections in the Slipfitter and knot wires for strain
relief.
3. To adjust the angle of the Slipfitter, remove Screws
(2) and remove the Slipfitter Cover Plate. Loosen the
Locking Bolt and swivel fixture to desired angle. The
graduation on the Slipfitter Cover Plate can be used as
guidelines to adjust the angle.
4. Tighten the Locking Bolt. Replace Slipfitter Cover Plate.
Tighten Screws.
5. Apply weatherproof silicone sealant and tighten Plug.
ALED260/ 360 with Slipfitter
Fixture
Plug
Screws (
2)
Slipfitter
Cover Plate
Slipfitter
Locking
Bolt
Set Screws
Tenon
(supplied by
others)
Publicité
Table des Matières
