Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
®
ALED 50W -150W WITH UNIVERSAL ARM INSTRUCTIONS
Thank you for buying RC lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments. Call the Marketing
Department at 888-722-1000 or email: marketing@rclighting.ca
0-10V DIMMABLE WIRING WITH WS
SENSOR
Universal voltage driver and WS Sensor permits operation
at 120V thru 277V, 50 or 60 Hz. For 0-10V Dimming with WS,
follow the wiring directions (Fig.7)
1. Connect the black fixture lead to the LOAD of WS Sensor.
2. Connect LINE of WS Sensor to LINE supply lead.
3. Connect the white fixture lead and NEUTRAL of WS
Sensor to the COMMON supply lead.
4. Connect the GROUND wire from fixture and WS Sensor
to supply ground. Do NOT connect the GROUND of the
dimming fixture to the output.
5. Connect the purple fixture lead to DIM + of WS Sensor.
6. Connect the gray fixture lead to the DIM - of WS Sensor
lead.
7. Cap the yellow fixture lead, if present. Do NOT connect.
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1. Clean glass lens with non-abrasive glass cleaning
solution.
2. Do not open fixture to clean the LED. Do not touch the
LED.
TROUBLESHOOTING
1. Check that the line voltage at the fixture is correct. Refer
to wiring directions.
2. Be sure the fixture is grounded properly.
3. Is the photocell, if used, functioning properly?
ACCESSORIES
LALED150-Door Lens replacement
•
Avaiable in Bronze, (W)White, (RG)Gray
•
GOALED150W-Wire Guard
Available in (G)Grey
Patent: US: pat. D668,370
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation, operation or maintenance.
Easy Answers / Résponses pratiques
Website / Comput site
© 2017 RC LIGHTING LLC
rclighting.ca
Northvale, New Jersey 07647 USA
ALED IN 0117
Tech Help Line / Ligne d'assistance technique
888 722-1000
DIMMABLE WIRING DIAGRAM
Dimmable
Driver
LED
POLE DRILLING DETAIL
Dimensions of the holes on RPA and Bracket.
This template is not to scale. Please use measurements
shown in Fig.8.
email / Courriel
Free Lighting Layouts / Plans d'éclairage gratuits
sales@rclighting.ca
Available online or by request / Disponibles en ligne ou sur demande
NEUTRAL
LOAD
14-18 AWG Solid CU Wire Only
FSP-211
High/Low PIR
Occupancy Sensor
230 VAC, 50 Hz
1200W max ballast
18-20 AWG Solid CU Wire Only
GRAY (-)
VIOLET (+)
FIG.7
FIG.8
Publicité
Table des Matières
