RC Lighting ALED3T105N Directives D'installation page 12

ALED 260W 360W INSTALLATION INSTRUCTIONS
®
Thank you for buying RC lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-722-1000 or email: marketing@rclighting.ca
ROUND POLE ADAPTOR ACCESSORY
For use with standard RC pole drilling.
1. Drill round pole using the dimensions shown in the Pole
Drilling Detail.
2. Place Round Pole Adaptor/ RPA (ordered separately)
and RPA Gasket between the fixture and drilled Pole as
shown.
3. Line up top holes of the Gaskets and Round Pole
Adaptor with top hole in the pole drilling pattern.
4. Place long 3/8" Bolts from the ALED through the top
hole of the RPA and Gaskets to the Round Pole thread
into Bolster Plate.
5. Feed wires from Fixture through Gasket into Arm. Feed
supply wires from Pole through Gasket into Arm. Make
necessary connections inside the Arm and knot wires for
strain relief.
6. Replace the Arm Cover, tighten Screws and add the
Plugs. Secure Pole cap.
Round Pole Adaptor (RPA) - Ordered separately
Arm Gasket
Bolster Plate
Round Pole
(not supplied)
RPA
Gasket
Plugs (2)
Screws (2)
Arm Cover
Long 3/8" Bolts
0-10V DIMMABLE WIRING
Universal voltage driver permits operation at 120V thru 277V,
50 or 60 Hz. 0-10V control wires must be rated for 300V
minimum. For 0-10V Dimming, follow the wiring directions as
shown in figure below.
1. Connect the black fixture lead to the LINE supply lead.
2. Connect the white fixture lead to the COMMON supply
lead.
3. Connect the GROUND wire from fixture to supply ground.
Do NOT connect the GROUND of the dimming fixture to
the output.
4. Connect the purple fixture lead to the (V+) DIM lead.
5. Connect the gray fixture lead to the (V-) DIM lead.
6. Cap the yellow fixture lead, if present. Do NOT connect.
PHOTOCELL INSTALLATION
Photocell may be installed in the field. Apply weatherproof
silicone sealant to all plugs and unused conduit entries.
1. Knockout hole on top of arm.
2. Install photocell and wire as per diagram.
3. Use photocell rated for your supply voltage.
PHOTOCELL
PHOTOCELL
BLACK
LIGHT
"COM"
WHITE WP2FC
FIXTURE