RC Lighting ALED3T105N Directives D'installation page 11

ALED 260W 360W INSTALLATION INSTRUCTIONS
®
Thank you for buying RC lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-722-1000 or email: marketing@rclighting.ca
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RC fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. This product must be installed in accordance with the applicable installation code by a person familiar with the
construction and operation of the product and the hazards involved.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
CAUTION: The fixture weighs 80lbs. Make sure pole and hardware supplied by others (if any) can withstand the weight of
the fixture.
MOUNTING ARM ON FIXTURE
1. Remove the Arm Cover from the Arm.
2. Feed wires from Fixture through Gasket into Arm.
3. Line up Arm and Fixture. Place flat washers, lock washers
and nuts on the Short 3/8-16 bolts inside the Arm and
tighten securely to housing.
4. Make sure the Gasket is secure between Arm and
Fixture.
Gasket
Short 3/8"
Bolts
Arm
Arm Cover
Screws (2)
Plugs (2)
ALED260/ 360
MOUNTING FIXTURE DIRECTLY TO
POLE
Check that pole is drilled according to Pole Drawing Detail.
1. Remove the Arm Cover from the Arm.
2. Feed wires from Fixture through Gasket into Arm. Feed
supply wires from Pole through Gasket into Arm.
3. Insert Long 3/8-16 bolts through Arm, Gasket, Pole
and thread into the Bolster Plate. Be sure the Gasket
is between the Arm and pole and secure with bolts,
washers and lockwashers.
4. Make necessary connections inside the Arm and knot
Fixture
wires for strain relief.
5. Replace the Arm Cover. Be sure the Gasket on Arm
Cover is in place. Tighten Screws and add the Plugs.
Secure Pole cap.
Pole Cap
Bolster
Plate
Gasket
Short 3/8" Bolts
Arm
Plugs (2)
Screws (2)
Long 3/8" Bolts
Arm Cover