Safety Of Others; Electrical Safety - Black & Decker HD4810 Mode D'emploi

ENGLISH
c. Disconnect the plug from the power source and/or the
battery pack from the power tool before making any
adjustments, changing accessories, or storing power
tools. Such preventive safety measures reduce the risk
of starting the power tool accidentally.
d. Store idle power tools out of the reach of children and do
not allow persons unfamiliar with the power tool or these
instructions to operate the power tool. Power tools are
dangerous in the hands of untrained users.
e. Maintain power tools. Check for misalignment or binding
of moving parts, breakage of parts and any other
condition that may affect the power tools operation. If
damaged, have the power tool repaired before use.
Many accidents are caused by poorly maintained power
tools.
f. Keep cutting tools sharp and clean. Properly maintained
cutting tools with sharp cutting edges are less likely to
bind and are easier to control.
5. Service
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts. This will
ensure that the safety of the power tool is maintained.
Additional power tool safety warnings
• Wear ear protectors with impact drills. Exposure to noise
can cause hearing loss.
• Use auxiliary handles supplied with the tool. Loss of
control can cause personal injury.
• Hold power tool by insulated gripping surfaces when
performing an operation where the cutting tool may
contact hidden wiring or its own cord. Contact with a
"live" wire will also make exposed metal parts of the
power tool "live" and shock the operator.
• Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding the
work by hand or against your body leaves it unstable and
may lead to loss of control.
• Before drilling into walls, floors or ceilings check for the
location of wiring and pipes.
• Avoid touching the tip of a drill bit just after drilling, as it
may be hot
4

Safety of others

• This tool is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
• Children should be supervised to ensure that they do not
play with the appliance.
6. Labels on tool
The label on your tool may include the following symbols:
Read Hz .......
Instructions
W .......
Manual
min .....
Use Eye
Protection
.....
Use Ear
Protection
.....
V ........ Volts
A ........ Amperes n ....... No-Load
0

Electrical safety

This tool is double insulated; therefore no earth wire is
required. Always check that the power supply
corresponds to the voltage on the rating plate.
• If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features (Fig. A)
1. Variable speed switch
(Only for HD5010VA5, HD5513V,
HD5513KA40,HD5513KHA)
2. Lock-on button
3. Forward/ reverse slider, Depth stop & Side handle
(Only for HD5513V, HD5513KHA, KHA40V)
...... Class II
Hertz
Construction
Watts
...... Earthing
Terminal
minutes
...... Safety
Alternating
Alert Symbol
Current
.../min.. Revolutions
Direct
or Recipro-
Current
cation per
minute
Speed