Fitting Storage Shelves; Power Supply - Gamko E3 Mode D'emploi

Fitting storage shelves

1
Hook pin into the opening of the rail and
push bottom part towards the side.
3
Fit the other pins at the same height.
4
Place the storage shelf, sliding the pins in the openings.

Power supply

• If this device's cable is damaged it must be replaced with an original cable supplied by the manufacturer
• In case of emergency: isolate from power supply.
• The socket should be within easy reach of the cabinet.
• Check for the correct power supply, referred to the information on the type plate.
• Ensure that the mains lead cannot be trapped or snagged.
• If necessary the mains lead can be extended by a qualified electrician.
• We do not recommend the use of an extension lead.
Fluctuations in the power supply can cause damage, which causes the cabinet to switch off.
Gamko cannot be held responsible for any consequential damage.
28
2 This causes the pin to slot into the
next opening in the rail.
E3