Gamko E3 Mode D'emploi page 31

Icon
+
+
Application with thermostat:
To see the set point;
The set key gives access to a quick menu where it is possible to see the following:
• The setpoint value.
• The actual setpoint value (rSE).
To change the set point;
1 Press and hold SET for more than 3 seconds.
2 The value of the set point is displayed and the "°C" LED starts blinking
3 Increase or decrease the setpoint with the increase or decrease of setting(s).
4 Temperature range between 2°C and 18°C degrees.
5 To remember the new setting value, press the (SET) setting button or wait for 60 seconds.
Note
• If the Probe (P1) message appears on the screen, contact the Gamko service department or your supplier.
E3
Description
Hold for 3 seconds to release or lock the keypad.
• The "Off" label appears on the display and the keyboard is unlocked.
• The "On" label appears and the keypad is locked.
Return to ambient temperature display
31