Troubleshooting - Gamko E3 Mode D'emploi

Troubleshooting

Attention
Always remove the plug from the socket when carrying out repairs.
The cabinet does not start
• Check the plug.
• Restore the power supply by replacing a fault fuse or by using the on/off switch.
• Contact your local service organisation.
Temperature is too high, in spite of recent adjustment of thermostat
• Check/restore power supply.
• Remove contents which may obstruct ventilation.
• Clean magnetic seal, or gasket, replace if necessary. Remove contents which may obstruct ventilation
• Defrost evaporator.
• Thermostat or compressor is defective.
• Fan (evaporator or condenser) is defective.
• Contact your local service organisation.
Temperature is too low, in spite of recent adjustment of thermostat
• Thermostat is defective.
• Contact your local service organisation.
Water leak
• Defrost regularly – if necessary extra manual defrost cycle.
• Check if the appliance is level. If necessary, level the appliance.
• Contact your local service organisation.
Thermostat notifications
• The code P1 appears in the display.
• Inform the Gamko service department or your supplier.
34
E3