Chapter 2 - Installation; Operating Principle; Installing The Appliance - Gamko E3 Mode D'emploi

Chapter 2 - Installation
Never install the
refrigerator next to a
heat source!

Operating principle

A refrigerator works by extracting heat from the space to be refrigerated and to release this in the surrounding
area. For maximum air circulation it is recommended to allow at least 10mm space around the refrigerator.
Be very careful never to obstruct the air inlets and outlets.
The advised maximal height of the load is marked with the load lines on the inside of the cabinet.

Installing the appliance

Place the appliance on a flat surface.
1
Place the appliance at his position.
2
Make sure the appliance is standing level using a spirit level.
3 The appliance must be placed with feet to provide adequate air circulation around the cabinet. This for
an optimal operation of the appliance and to dispose of possible leakages of R600a. Also, the legs are
used for appliance adjustment and leveling.
4
Adjust the stands (1) with 6 mm Allen wrench in the openings (2) until the product is level
5
Tighten the screws (3) of the foot pieces (1), at the bottom, with a wrench, when the adjusting device is
not accessible from the inside.
6
Plug the openings (2) on the inside with the supplied caps
7
If the legs are not assembled, the holes in the bottom must be filled with the insulating caps provided to
prevent condensation and loss of energy. This is to prevent condensation and loss of energy.
26
E3