Troubleshooting Guide - Heath Zenith 5872 Mode D'emploi

SYMPTOM
The light will not come on.
The light comes on during
the day.
The light comes on for no
apparent reason.
The lights stay on
continuously.
The lights flash on and off.
The lights flash once then
stay off in manual mode.
6

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE
1. Light switch is turned off.
2. Fuse is blown or circuit breaker is turned off.
3. Daylight turn-off (photocell) is in effect.
4. The circuit wiring is incorrect, if this is a new
installation.
5. The motion sensor is aimed in the wrong
direction.
6. The outside air temperature is close to the
same as a person's body heat.
1. The motion sensor may be installed in a
relatively dark location.
2. The "ON-TIME" switch is in the "TEST"
position.
1. The motion sensor may be sensing small
animals or automobile traffic.
2. The "SENS" switch is set too high.
3. The outside temperature is much warmer or
cooler than a person's body heat (summer or
winter).
4. The light fixture is wired through a dimmer
or timer.
1. The motion sensor may be picking up a heat
source like an air vent, dryer vent, or brightly
painted, heat-reflective surface.
2. The motion sensor is in manual mode.
3. The light fixture is wired through a dimmer
or timer.
4. The light fixture is on the same circuit as a
motor, transformer, or fluorescent bulb.
1. Heat or light from the lamp heads may be
turning the motion sensor on and off.
2. Heat is being reflected from other objects
and may be turning the motion sensor on
and off.
3. The motion sensor is in "TEST" mode and
warming up.
The motion sensor is detecting light from the
lamp heads.
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
SOLUTION
1. Turn light switch on.
2. Replace fuse or turn circuit breaker on.
3. Recheck after dark.
4. Verify wiring is correct.
5. Re-aim the motion sensor to cover the
desired area.
6. Increase the "SENS" setting. See Seasonal
Changes on page 5 for more information.
1. The light fixture is operating normally under
these circumstances.
2. Set the "ON-TIME" switch to the 1, 5, or 20
minute setting.
1. Decrease the "SENS" setting or reposition
the motion sensor.
2. Decrease the "SENS" setting.
3. Decrease the "SENS" setting. See Seasonal
Changes on page 5 for more information.
4. Do not use a dimmer or timer to control the
light fixture. Replace the dimmer or timer
with a standard on/off wall switch.
1. Decrease the "SENS" setting or reposition
the motion sensor.
2. Set ON-TIME switch to 1, 5, or 20 minutes.
Follow Manual Mode instructions on page 5
to reset.
3. Do not use a dimmer or timer to control the
light fixture. Replace the dimmer or timer
with a standard on/off wall switch.
4. Install the light fixture on a circuit without
motors, transformers, or fluorescent bulbs.
1. Reposition the lamp heads away from the
motion sensor.
2. Decrease the "SENS" setting or reposition
the motion sensor.
3. While in TEST mode, the light only stays on
for 8 seconds. Set ON-TIME switch to 1, 5,
or 20 minutes.
Reposition the lamp heads to keep the area below
the motion sensor relatively dark.
208802-03