Husqvarna TS 400 F Manuel D'utilisation Et D'entretien page 30

The disc locking nut has a left-hand
thread.
If the machine is fitted with a brake
motor, do not use the quick-tighte-
ning nut.
Take care about the direction of rota-
tion which is shown by an arrow on
one of the faces.
Make sure the contact faces of
flanges, of blade and the axle are
clean.
=
?
Always pay extreme care and atten-
tion to the preparation of the machine
before starting up
Remove all adjustment tools and
wrenches from floor and machine
Always keep blade guard in place
As each machine is fitted with a self priming
pump, the water is sprayed onto the disc as
soon as the machine starts.
Ensure that the water supply is abundant,
when cutting wet.
The protective case and the motor mounting
fitted with a deflector blade provide perfect
distribution of the spray.
phase motor protected by a built-in thermal cir-
cuit breaker.