EXIT Toys Galaxy Mode D'emploi page 14

Masquer les pouces Voir aussi pour Galaxy:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40
19
First loosen the M10X100mm bolt assembled, the M10X100mm bolt isn't used in this sys-
tem.
1.
Attach rear struts (28,29) to Front Base Frame (23) using two M8X55mm button bolts
(B1) and two M8 washers (D2), two M8 spring washers (G1) and two M8 locknuts
(C2).
Do not tighten the locknuts.
2.
Remove the M10X80mm bolts (A13) assembied on step 16.
3.
Then, attach four struts (28, 29, 30 and 31) to the four base assembly (22) using two
M10X80mm bolts (A13), four M10 washers (D3) and two M10 locknuts (C3).
Do not tighten the locknuts.
4.
Attach struts (28, 29, 30, and 31) to the bottom pole (3) using an M10X120mm bolt
(A27), two M10 washers (D3) and an M10 locknut with cap (C5).
Finally, tighten all of the bolts in this step.
20
1.
Make sure all the bolts are tightened in the system.
2.
Place the other sandbags (33). Pull the zipper well.
21
1.
Use the rear handle for adjusting the rim height.
2.
Use the front handle for moving the system.
3.
In case of uneven ground, you can adjust the adjustment foot.
Note: Check whether the entire system is tight. If the system is loose, please cor-
rect and tighten all the nuts.
22
Instructions:
A. To adjust the rim height, follow the steps below:
1.
Turn the knob to free the adjustment knob (5). See picture (1);
2.
Then grasp the slider handle and rear handle (14) to pull the frame up or down to a
hole preferred by you and click the knob back. See picture(3);
3.
Tighten the adjustment knob (5). See picture (2).
B. In case of uneven ground, you can adjust the adjustment foot. See picture(4).
C. To move the basketball system, follow steps below to adjust:
1.
Loosen the two M12 nuts, turn the two adjustment feet back, which should lower the
wheel carriage assembly. See picture (5).
2.
Move to the right place. Turn the two feet higher than the front base assembly and
adjust their length to make sure the system is even with the ground. See picture (6).
3.
Tighten M12 nut securely.
Note: This step requires two people.
23
1.
Fix the frame to the surface
14
Galaxy
Basketball Systems

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Polestar

Table des Matières