EXIT Toys Galaxy Mode D'emploi page 12

7
Attach the bottom arm (6) to backboard bracket (10) using an M12X225mm bolt
(A22), two M12 washers (16), and an M12 locknut (C4).
Do not tighten the bolt yet.
8
Install the upper arm (7) to the top pole (1) using an M12X225mm bolt (A22), two
M12 washers (16), two big plastic spacers (18) and an M12 locknut (C4).
Do not tighten the bolt yet.
9
Install the bottom arm (6) to top pole (1) using an M12X225mm bolt (A22), two M12
washers (16), two big plastic spacers (18) and an M12 locknut (C4).
Do not tighten the bolt yet.
10
Install the spring arm (8) to top pole (1) using an M10X135mm bolt (A17), two M10
washers (D3), two M10 plastic washers (15) and an M10 locknut (C3).
Do not tighten the bolt yet.
11
1. Assemble the rear handle (14). Attach the rear handle (14) to the adjustment
arm (13) using two M8X55mm button bolts (B1), two M8 spring washers (G1),
and two arc washers (F1).
2. Attach the adjustment arm (13) to the bottom arm (6) using an M12X225mm
bolt (A22), two M12 washers (16), and an M12 locknut (C4). Do not tighten
the bolt yet.
3. Then, attach the adjustment arm (13) to the adjustment slider (4) using an
M10X88mm bolt (A14) and an M10 locknut wit cap (C5). Do not tighten the
bolt yet.
12
1. Assemble the spring (12). Attach the closed ends of the two springs (12) to the
spring arm (8) using an M10X135mm bolt (A17), two M10 washers (D3), and an
M10 locknut (C3).
2. Then, attach the spring (12) to the bottom arm (6) using an M12X225mm bolt
(A22), two M12 washers (16), and an M12 locknut (C4).
3. Use a wrench to hang the spring (12) on the M12X225mm bolt (A22).
Note: Tighten all of the bolts in the steps.
12
Do not over tighten the locknuts on the pivot parts.
Galaxy
Basketball Systems