Barrette rdi Serie Instructions D'installation page 3

IMPORTANT NOTES:
This Kit can accommodate 3 different install variations.
Use Instructions included in Privacy Rail kits to set posts
accordingly.
If cutting the width of the section down use calculations below
for rails, rail adaptors, infill boards and decorative screen
panels.
"X" = Inside Edge of Post
Rail Length = "X" + 2.75"
Infill Board Length = "X" + 2"
See Figure A for reference.
Install Method 1: 36" or 42" Rail Heights
1.
For 42" (6 boards) Mid rail installation height a 2"
bottom space is used. For a 36" (5 boards) mid
rail height a 3
Once posts are set, place the spacer blocks to
support the bottom rail.
2.
Place bottom rail inside the posts, resting it on
the 2" spacer blocks (Fig. 2).
TIP:
The rail may need to be inserted at an angle in
one post to start before resting it fully on the
blocks and in both posts (Fig. 2).
3.
Pre-drill rail using a
rail using two
Head Driver. Bottom screw should be
the bottom of the bottom rail. Screws should be
2" apart from each other. (Fig. 3).
⁄ " bottom space is recommended.
1
2
⁄ " drill bit. Attach bottom
1
8
⁄ " Hex Head screws with
3
4
⁄ " Hex
5
16
⁄ " from
3
4
64"
Inside Edge
of Post
"X"
2"
2"
⁄ "
3
4
Fig. A
Fig. 1
Fig. 2
Fig. 3
3