Barrette rdi Serie Instructions D'installation page 8

5.
Back out the top screw so that the channel
is clear until infill boards are installed (Fig. 5).
Repeat Steps 2 & 3 on other post.
6.
Slide the vertical post adaptors into each post.
Make sure the adaptor sits behind the face of the
post and in front of the first groove in the posts
(Fig. 6). Guide these down until they contact the
bottom rail.
7.
Once decorative screen panel is modified to the
width of the panel it can now be inserted into the
lower section of the rail (no height modification
needed). Slide the panel down the vertical
adaptors and seat it fully into the bottom rail.
8.
Install mid rail.
9.
Cut two of the vertical post adaptors for the top
section to 28 ¼". Cut the height of the decorative
screen panel to 31".
8
Fig. 5
Fig. 6
Fig. 7