Proper Use; Technical Data; Suction Nozzles; Before Starting The Equipment - EINHELL TE-VC 18 Li Mode D'emploi D'origine

•
Upholstery nozzle
•
Crevice nozzle
•
Combination nozzle
•
Extension tube
•
Filter
•
Original operating instructions
•
Safety information

3. Proper use

The vacuum cleaner is designed for dry vacu-
uming using the appropriate fi lter. The equipment
is not suitable for the vacuuming of combustible,
explosive or harmful substances.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Motor power supply: ............................... 18 V DC
Tank volume: ...............................................0.54 l
Weight: .....................................................0.85 kg

5. Before starting the equipment

Warning!
Always remove the battery pack before making
adjustments to the equipment.

5.1 Assembling the equipment

Fitting the nozzles (Fig. 1-2)
The nozzles (5, 6, 7) can be fi tted to the vacuum
cleaner either directly on the intake opening (10)
or via the extension tube (8).
Anl_TE_VC_18_Li_SPK7.indb 14 Anl_TE_VC_18_Li_SPK7.indb 14
GB
Fitting/removing the fi lter (Fig. 1-4)
Press the locking switch (4) and remove the tank
at the same time (3). You can then take the fi lter
(9) out of the tank (3) (Fig. 3).
The fi lter (9) must be completely taken apart to
enable it to be thoroughly cleaned (Fig. 4).
After cleaning, fi t the fi lter (9) back in the tank (3)
(Fig. 3). Then fi t the tank (3) back on the vacuum
cleaner (Fig. 5).

5.2 Suction nozzles

Combination nozzle (Fig. 2)
The combination nozzle (7) is for vacuuming so-
lids over medium to large areas.
Crevice nozzle (Fig. 2)
The crevice nozzle (6) is designed for vacuuming
solids in corners, edges and other areas that are
diffi cult to access.
Upholstery nozzle (Fig. 2)
The upholstery nozzle (5) is specially designed
for vacuuming solids on upholstery and carpets.
5.3 Charging the Li battery pack (Fig. 6-7)
1. Remove the battery pack (a) from the handle,
pressing the pushlock button (b) downwards
to do so.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
(c) into the socket outlet. The green LED will
then begin to fl ash.
3. Push the battery pack (a) onto the battery
charger (c).
In section 10 (Charger indicator) you will fi nd a
table with an explanation of the LED indicator on
the charger.
If the battery pack fails to charge, check for the
following:
•
voltage at the power socket
•
whether there is good contact at the charging
contacts of the charging unit
If the battery pack still fails to charge, send
•
the charger and charging adapter
•
and the battery pack
to our customer service center.
- 14 -
Autogoods "130"
02.05.16 12:50 02.05.16 12:50