Proper Use; Technical Data; Before Starting The Appliance - EINHELL RT-VC 1500 WM Mode D'emploi

Anleitung_RT_VC_1500_WM_SPK7:_
GB
16 Foam filter
17 Screws
18 Anchor fittings
19 Handle with remote control
20 Battery
Original operating instructions
The extraction hose and its accessories are a 35
mm system, compatible with the standard
accessories.

3. Proper use

The wet and dry vacuum cleaner is designed for wet
and dry vacuuming using the appropriate filter. The
appliance is not suitable for the vacuuming of
combustible, explosive or harmful substances.
The appliance may only be used for the tasks it is
designed to handle. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our appliance has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be void if the appliance
is used in commercial, trade or industrial businesses
or for equivalent purposes.

4. Technical data

Mains voltage:
Power input:
Protection class:
Weight:
Container volume:

5. Before starting the appliance

Before you connect the appliance to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the appliance.
Assemble the exhaust air diffuser. (Fig. 3)
16
16.07.2010 11:40 Uhr
5.1 General Assembly (Fig. 4)
Assemble the wall mount so that the distance
between the intake and the floor is no more than
1.5 m.
Screw the wall mount to the wall. Secure the wall
mount with the bolts.
No other weight should be placed on the wall
mount except for the appliance itself.
Do not place a weight of more than 18 kg on the
wall mount.
Insert the hose suspension bracket into the
aforementioned holes which are situated above
the wall mount. Make sure the bend in the bracket
faces away from the wall.
Choose an area for the wall mount which is close
enough to a socket which the cable can reach.
Regularly test the hold of the wall mount.
5.2 Fastening the wall mount to a wooden wall
(Fig. 5)
Make sure that the wall mount is level and mark
the positions of the holes.
Secure the wall mount with the screws and the
anchor bolts.
5.3 Fastening the wall mount to a wall (Fig. 6-9)
Choose a solid wall for the wall mount.
Place the wall mount in the desired place and
make sure the mount is level. Mark the positions
of the holes. The holes should not be drilled into
the mortar, but into the solid wall.
Insert the screws into the holes in the wall mount.
Attach the washers and dowels from the other
side.
Screw the nut onto the end of the screw. Tighten
the nuts by one turn together with the conical
220-240 V ~ 50 Hz
anchor to make sure that the connection is not
loose.
1500 W
Insert the bolts into the three holes in the wall and
II
assemble the wall mount in position.
9.5 kg
5.4 Attaching the wet and dry vacuum cleaner to
18 l
the wall mount. (Fig. 10-14)
Push the wet and dry vacuum cleaner into the two
holding devices (A) and the frame of the wall
mount (B) from above.
Attach the accessory holder in the
aforementioned place.
Insert the end of the vacuum tube into the
connection on the appliance.
Attach the desired accessory.
Press the release lever to remove the wet and dry
vacuum cleaner. Pull the wet and dry vacuum
cleaner out of the wall mount with the right hand
using an upward motion.
Seite 16