Changing Presser Feet; Changing Needle - Texi Joylock 2/4 Manuel D'utilisation

CHANGING PRESSER FEET

Be sure needle is in the up position.
Raise presser foot lever.
1.
Push foot release lever to remove
the foot.
2. Place the desired foot on the needle
plate aligning needle holes.
3. Lower the presser foot lever and
push foot release lever so that the
foot holder snaps on the foot.

CHANGING NEEDLE

Raise needle bar to its highest point by turning
hand wheel towards you, but leave presser foot
down. Loosen needle clamp screw to remove the
needle, and place new needle with Flat Side
Away From you, into the needle bar as far as it
will go, and tighten screw.
NEEDLE TYPE: 130/705 H (HAx1)
NOTE: Keep in mind that the lower and upper
loopers will use about twice the amount of thread
as the needles. When purchasing thread for sewing, therefore, especially if it is an
unusual colour, you should buy sufficient for your requirements.
Texi Joylock 2-4 instrukcja 2017.indd 65 Texi Joylock 2-4 instrukcja 2017.indd 65
Texi Joylock 2/4
EN
65
18.09.2020 11:48 18.09.2020 11:48