Accessories; Changing The Presser Foot - Texi Ballerina Mode D'emploi

TEXI Ballerina manual operation

ACCESSORIES

Accessories are provided in the accessory case.
1. Needle set
2. Bobbins
3. Spool pin cap (large)
4. Spool pin cap (small)
5. Needle plate screwdriver
6. Screwdriver (large and small)
7. Buttonhole opener with brush
8. Blind hem foot
9. Overcasting foot
10. Zipper foot
11. Buttonhole foot
12. Satin foot
OPENING ACCESSORY CASE
To open the accessory case, lift up on the top left side of the table
and pull toward you.
CONVERTING TO FREE-ARM MACHINE
Your machine can be used either as a flat-bed, or as a free-arm model.
With the extension table in position, it provides a working surface as a standard
flat-bed model. Be removing the extension table (just pull it off to the left as shown),
the machine converts into a free-arm model.
DUST COVER
Cover the machine with dust cover when it is not used.

CHANGING THE PRESSER FOOT

The presser foot must be changed according to the sewing job or stitch you sew.
CAUTION: Turn OFF the power switch before you change the presser foot.
1. Turn the handwheel toward you until the needle is at its highest position.
2. Raise the presser foot.
3. Remove the presser foot by pushing the presser foot release lever toward you.
4. Place desired foot with its pin (A) directly under the slot (B).
5. Lower the presser foot lifter and the presser foot will snap into place.
REMOVING THE PRESSER FOOT HOLDER
You may need to remove the presser foot holder to use some presser feet.
To remove, raise the presser foot lifter and loosen the presser foot thumb
screw (C).
To attach, tighten the screw after raising the presser foot holder.
130
(A) Presser foot pin
(B) Presser foot holder pin
(C) Presser foot thumb screw