Scallop Stitch; Caring For Your Machine - Texi Ballerina Mode D'emploi

TEXI Ballerina manual operation

SCALLOP STITCH

(1) SCALLOP HEM
1. Fold the fabric with right sides together and sew near the edge.
2. Cut the fabric along seam leaving an allowance of 3 mm (1/8")
for seaming. Notch the allowance.
3. Turn fabric with right sides out and gently push out curved seam
press.
(2) DECORATIVE SCALLOP EDGE
1. Place te fabric with left sides together and stitch near the edge.
2. Trim along the outside edge of the stitching.
3. Use seam seleant or fabric glue to secure edges of the scallop
stitching.
ADJUSTING DECORATIVE PATTERNS
Use the open toe foot for continuous decorative stitch patterns.
An indentation on the underside permits the flow of satin stitching
and the open front allows clear visibility.
To tailor decorative stitch patterns, adjust the length and width of
the pattern. More LCD lights results in a longer or wider stitch pattern.
Fewer LCD lights gives you a shorter or narrower stitch pattern.
NOTE: When sewing lightweight fabrics, it is suggested that you use
interfacing on the backside of the fabric.

CARING FOR YOUR MACHINE

To ensure the best possible operation of your machine, it is necessary to
keep the essential parts clean at all times. Always disconnect the machine
from power supply by removing the plug from the electric outlet.
1. Raise the needle
2. Remove the needle plate (1)
3. Remove the bobbin and bobbin case (2)
4. Clean the feed dogs and hook area with the lint brush.
NOTE: Put drop of sewing machine oil on the hook race as indicated
by the arrow A.
5. Replace the bobbin case with the projection (3) positioned against
the spring (4). Replace the needle plate.
These stitches are used to sew a decorative edge
on garments and table cloths.
143
Right
side
Left
side