Sewing Test; How To Sew A Chain Pattern; If Threads Break During Sewing; How To Adjust The Presser Foot Pressure - Texi Pierrot Mode D'emploi

TEXI Pierrot operation manual

Sewing test

How to sew a chain pattern

If threads break during sewing

How to adjust the presser foot pressure

Pressure adjustment screw
More pressure
Less pressure
All manuals and user guides at all-guides.com
Start the sewing test after the threading is completed.
1. Raise the presser foot. Place a piece of waste cloth under the presser foot.
Lower the presser foot. Start to sew. While the machine is sewing, do not
raise the presser foot, or the sewing will be uneven.
2. Before you operate the foot controller, use your left hand to hold the thread
gently and use your right hand to turn the hand wheel counter clockwise.
At the same time check the sewing status.
3. Operate the foot controller gently.
After the sewing test is completed, keep on pressing on the foot controller
genty until the chain is approx. 10 cm. Then the thread will become a chain
pattern automatically.
* If the tension is uneven, the chain pattern will not be even. If such event
happens, please hold the thread gently and verify the threading order and
also adjust the thread tension. Then the chain pattern will be even.
* If thread breaks during the sewing please remove the cloth.
Thread the machine in the correct threading order. Thread the upper looper,
lower looper and the right needle.
NOTE: Do not pull on the fabrics while sewing as this may deflect the needle,
causing it to break.
* The pressure of the machine is readjusted for sewing
* It may be necessary to adjust the pressure to sew
For light weight fabric - decrease pressure.
For heavy weight fabric - increase pressure.
116
medium weight fabrics.
different weights of fabrics by turning the pressure
regulationg screw.