Caring For Your Machine; Replacing Moving Cutter; Disengaging Moving Cutter; Removing Face Cover - Texi Joylock 2/4 Manuel D'utilisation

Table des Matières

Les langues disponibles

3. CARING FOR YOUR MACHINE

Replace a moving cutter if it becomes blunt

as follows. A spare cutter will be found in your

accessories.

NOTE: You should not need to replace fixed

cutter, which is made of special hard alloy

material.

FIRST REMOVE THE POWER PLUG FROM THE

SUPPLY SOCKET-OUTLET.

Loosen screw and take out moving cutter.

Close the working table. Lower cutter

driving arm to its lowest position by turning

the hand wheel towards you by hand. In

this position, set replacement cutter in

position and secure it with screw, ENSURING THAT THE EDGE OF THE MOVING

CUTTER IS APPROXIMATELY 0.5 MM BELOW THE SURFACE OF THE FIXED CUTTER.

If you want to sew without cutting, open the

working table and disengage the moving cutter

by pushing the cutter release knob to the left and

turning it towards you as illustrated.

Ensure that fabric edge is not wider than

overedge width selected or upper looper and

needle can be damaged.

Disconnect from power supply before

removing face cover.

Remove the screw and take off the face

cover.

Texi Joylock 2-4 instrukcja 2017.indd 79

Texi Joylock 2/4

18.09.2020 11:48

Table des Matières