Velleman 802 Mode D'emploi page 2

This device is designed as an add-on to existing power door locking system. When
arming/disarming an alarm system, the device will control the door automatic lock/unlock. It will
provide more convenient for you and more secure to your vehicle.
Warning : Use the information enclosed as a guide only. Car makers are constantly changing wire
colours and system types. Determine the type of system the vehicle has before
proceeding.
Be sure to disconnect the car's battery before installing, and to install this device in a suitable
position of interior car.
1. 3-WIRE PLUG
A. RED WIRE
Connect to a positive constant power supply (+12V)
B. BLACK WIRE
Connect to a good chassis ground. (-)
C. BLACK/WHITE WIRE
Connect to alarm system's negative power output wire. (SP500'B)
2. 6-WIRE PLUG
A. YELLOW, VIOLET AND VIOLET/WHITE WIRES
This is door unlock wire set.
Connect yellow wire to "N/C", violet wire to "COM", violet/white wire to "N/O"
B. WHITE, BLUE AND BLUE/WHITE WIRES
This is door lock wire set.
Connect white wire to "N/C", blue wire to "COM", blue/white wire to "N/O"
Note : The blue/white wire and violet/white wire are with one 10A inline fuse.
3. GREEN WIRE LOOP (DOOR LOCK TIMER SELECTOR)
Some newer vehicle require longer pulse time to activate the door locks, keep this wire loop for
normal pulse 0.6 seconds. Cut this wire loop for increased pulse time 3.6 seconds.
802
OPERATING MANUAL 802
POWER DOOR LOCK INTERFACE
INSTRUCTION
INSTALLATION
2 VELLEMAN