Ga.Ma Salon Exclusive DUE LITIO Manuel D'utilisation page 8

CHARGING PROCESS:
Before charging the hair clipper for the first time we recommend fully discharging the battery and then fully
charging it.
1. Make sure that the appliance is switched off.
2. Plug the adapter into the power outlet and then connect it to the device. The charging LED on the lower
part of the battery will light up and remain red for the whole charging process. The device can also be
charged via a dedicated charging base; a red LED light will turn on when the adapter is placed directly on
the base. Furthermore, the charging base features a dedicated stand to charge the additional battery
supplied. The second battery can be charged together with the hair clipper or alone. In the first case, only
the LED light on the base will turn on; in the second case, the LED light on the lower part of the battery will turn on.
The first charge takes 3 hours. Subsequent charges take about 2 hours. When fully charged, each battery
will last about 120 minutes.
3. Disconnect the adapter from the outlet once the device is fully charged.
4. The hair clipper may be used connected directly to the power outlet if the battery charge is depleted.
The duration of the battery varies based on usage frequency and times. To increase the lifespan of the
batteries, this procedure should be carried out at least twice every 12 months, discharging the battery
completely and recharging it for the maximum time. If the appliance is not used often, remember in any case
to carry out a charging cycle every so often during the year to keep it working efficiently. On the contrary,
when the charging is finished, do not keep the appliance connected to the mains to prevent the battery from
overcharging and damaging the appliance.
BATTERY INSERTION AND REPLACEMENT:
One of the available batteries is already installed inside the hair clipper. To replace it, press and hold the
button on the back of the product and slide it towards you. For install it, place the battery on the hair clipper
base and push it inwards until you hear a gentle click: insertion will now be completed.
CAUTION:
Lubricate the blade before the first use. Read the instructions contained in the section "HOW AND WHEN TO
LUBRICATE THE BLADE"
12
USE INSTRUCTIONS:
• Insert the desired attachment. This operation should always be done with the hair clipper turned off.
• Turn on the hair clipper by pressing the power button
• Turn off the hair clipper by pressing the power button
INSERTION OF COMBS:
The supplied combs have two lateral seats for an easier snapping on the base. To insert them on the hair
clipper, lay the blade on the comb and make it slide on the comb until you hear a slight click: the comb will
thus be properly inserted. To remove the combs just extract them making the blade slide outwards.
CUTTING LENGTH ADJUSTMENT:
DUE LITIO can be used for trimming and finishing touches, when used without attachment comb and with the
blade regulator on the main body, which features the following lengths: 0.8 mm, 1.1 mm, 1.4 mm, 1.7 mm and
2.0 mm. Otherwise, you can use the four attachment combs supplied to achieve a classic hair cut to the
following lengths: 3 mm, 6 mm, 9 mm and 12 mm.
CORD-CORDLESS FUNCTION:
This function makes it possible to use the hair clipper with and without the cord. If the appliance does not have
sufficient charge for use, it can be connected directly to the power supply without interrupting the cutting in
progress.
CLEANING AND MAINTENANCE:
A clean and properly lubricated hair clipper considerably improves its capacity and cutting precision.
DO NOT CLEAN ANY PART OF THE APPLIANCE UNDER RUNNING WATER.
CLEANING THE HEAD:
Before any cleaning operation, make sure that the appliance is properly turned off and disconnected from the
power outlet. Remove the accessory if it is inserted. Using the special brush supplied, remove any hair
residues between the blades and the back of the blade head.
NEVER DISASSEMBLE THE HEAD OF THE BLADE OR YOU WILL INVALIDATE THE WARRANTY ON THE
ENTIRE PRODUCT.
.
.
13