Options And Accessories - Hatco IWB Série Manuel D'installation Et D'utilisation

English
Slanted Base Option
a slanted base option is a factory-installed option available for
all models. The kit converts the unit into a slanted model.
NOTE: Water will not completely drain from unit with the
slanted base installed.
1. Lift the unit and slanted base out of the wooden shipping
frame, and carefully lower them into the countertop cutout.
This step requires two or more people, depending on the
unit.
• The slanted base is not attached to the unit. make sure
to lift the unit and the slanted base together out of the
wooden shipping frame .
2. apply National Sanitation Foundation-approved (NSF-
approved) silicone sealant around the edge of the unit to
seal it to the slanted base.
3. apply NSF-approved silicone sealant around the edge of
the slanted base to seal it to the countertop.
4. Follow the appropriate plumbing procedures in the
INSTaLLaTION section.
Installing a Slanted Base Option
Pan Support Bars
accessory pan support bars are available to divide wells into
sections for different size pans.
CWB12BAR ..........12" (305 mm) Pan Support Bar
(Not available for IWB-S1 models)
CWB20BAR ..........20" (508 mm) Pan Support Bar
(Not available for IWB-SX series)
Form No. IWBm-0816
Slanted
Base
Countertop
Cutout
9

OPTIONS AND ACCESSORIES

20" (508 mm)
Pan Support Bar
1/2
Full Size
Pan
Pan
1/2
Pan
Pan Support Bar Configurations (IWB-3 model Shown)
12" (305 mm)
Pan Support Bar
1/3
Pan
1/3
Pan
Two 1/6
Pans