Vente Unique Vogue Spa Installation Et Mode D'emploi page 45

General Messages
Priming Mode – MO19
Each time the spa is powered up, it will enter Priming Mode. The purpose of Priming Mode is to allow the user to run each pump and
separately, and is generally not possible in normal operation. Priming Mode lasts 4 minutes, but you can exit it earlier by pressing any
Temp button. The heater is not allowed to run during Priming Mode.
NOTE: If your spa has a Circ Pump, it will turn on with "Light" in Priming Mode. The Circ Pump will run by itself when Priming Mode is
exited.
Water Temperature is Unknown
After the pump has been running for 1 minute, the temperature will be displayed.
Too Cold - Freeze Protection
A potential freeze condition has been detected, or the Aux Freeze Switch has closed, and all pumps and blower are activated, either one
at a time, or all at once, depending on how your system was built. All pumps and blower are ON for at least 4 minutes after the potential
freeze condition has ended, or when the aux freeze switch opens.
In some cases, pumps may turn on and off and the heater may operate during Freeze Protection.
This is an operational message, not an error indication.
Water is too Hot (OHS) – MO29
One of the water temp sensors has detected spa water temp 110°F (43.3°C) and spa functions are disabled. System will auto reset when
the spa water temp is below 108°F (42.2°C). Check for extended pump operation or
high ambient temp.
J29 Warning – MO44
J29 is typically used as a Heater Disable input. As such, it should not typically be shorted at power-up. This message appears if J29 is
shorted at power-up.
M0XX numbers are Message Codes. See Page 18.
* This message can be reset from the topside panel with any button press.
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815,
7030343, 7,417,834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. Allmaterial copyright
of Balboa Water Group.
This typically requires observing the output of each pump
44