Vente Unique Vogue Spa Installation Et Mode D'emploi page 29

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Fill it up!
Preparation and Filling
These sequences are
Priming Mode - MO19*
This mode will last for 4-5 minutes or you can manually exit the priming mode after the pump(s) have primed.
Regardless of whether the priming mode ends automatically or you manually exit the priming mode, the system will automatically starts
, but the
pump(s) can be energized by pushing the "Jets"
or "Aux" buttons.
If the spa has a Circ Pump, it can be activated by pressing the "Light" button during Priming Mode.
Priming the Pumps
As soon as the above display appears on the panel, push the "Jets" button once to start Pump 1 in low-speed and then again to switch to
high-speed. Also, push the "Jets 2" or "Aux" button, if you have a 2nd pump, to turn it on. The pumps will now be running in high-speed to
continue to run. Turn off the pumps and repeat the process. Note: Turning the power off and back on again will initiate a new pump priming
session. Sometimes momentarily turning the pump off and on will help it to prime. Do not do this more than 5 times. If the pump(s) will not
prime, shut off the power to the spa and call for service.
Important: A pump should not be allowed to run without priming for more than 2 minutes. Under NO circumstances should a pump be
allowed to run without priming beyond the end of the 4-5 minute priming mode. Doing so may cause damage to the pump and cause the
system to energize the heater and go into an overheat condition.
Exiting Priming Mode
You can manually exit Priming Mode by pressing the "Warm" or "Cool" button. Note that if you do not manually exit the priming mode as
described above, the priming mode will be automatically terminated after 4-5 minutes. Be sure that the pump(s) have been primed by this
time.
Once the system has exited Priming Mode, the top-side panel will momentarily display the set temperature but the display will not show the
water temperature yet, as shown below.
display it.
*MO19 is a Message Code. See Page 18.
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815,
7030343, 7,417,834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. Allmaterial copyright
of Balboa Water Group.
28

Publicité

Table des Matières
loading

Produits Connexes pour Vente Unique Vogue Spa

Ce manuel est également adapté pour:

Tp500Tp500s

Table des Matières