Diagnostic Lights - Dell OptiPlex SX280 Serie Guide De Référence Rapide

Masquer les pouces Voir aussi pour OptiPlex SX280 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Power Light
Problem Description
Solid green power
The monitor may be faulty or
light and no beep
incorrectly installed.
code and no video
during POST
Solid green and a
A problem was detected while the BIOS
beep code during
was executing.
POST
Solid yellow
The Dell Diagnostics is running a test,
or a device on the system board may be
faulty or incorrectly installed.
Blinks green several
A configuration error exists.
times and then turns
off
Blinking green
The computer is in the suspended state
(Microsoft
Windows XP).
Solid green
Power is on, and the computer is
operating normally.

Diagnostic Lights

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
To help you troubleshoot a problem, your computer has four lights labeled "A," "B," "C," and "D" on
the back panel (see page 9). The lights can be yellow or green. When the computer starts normally,
the patterns or codes on the lights change as the boot process completes. If the POST portion of
system boot completes successfully, all four lights display solid green. If the computer malfunctions
during the POST process, the pattern displayed on the lights may help identify where in the
process the computer halted.
®
®
Windows
2000 and
Suggested Resolution
Check "Diagnostic Lights" on page 23 to see
if the specific problem is identified.
See "Running the Dell™ IDE Hard Drive
Diagnostics" on page 27 for instructions on
diagnosing the beep code. Also, check the
diagnostic lights to see if the specific problem is
identified.
If the Dell Diagnostics is running, allow the testing
to complete.
Check "Diagnostic Lights" on page 23 to see
if the specific problem is identified.
If the computer does not boot, contact Dell for
technical assistance.
Check "Diagnostic Lights" on page 23 to see
if the specific problem is identified.
Press the power button to wake the computer.
No corrective action is required.
Quick Reference Guide
23

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dctr

Table des Matières