Monacor PA-102 Mode D'emploi page 7

Masquer les pouces Voir aussi pour PA-102:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
5 Connections
Connections should only be made by qualified
experts . Always switch off the amplifier before
connecting!
1) Connect the plug (13) of the microphone
provided to the jack MIC (2) .
2) The jacks AUX (3) can be used to connect an
audio unit with line output level (e . g . MP3 / CD
player, radio, cassette recorder) .
3) Connect the speaker (minimum impedance:
4 Ω) or a speaker group with a total imped-
ance of at least 4 Ω to the terminal* SPEAKER
OUTPUT (10) .
4) Finally connect the 12 V operating voltage
(minimum current rating: 2 A) to the terminal*
12 V ⎓ (9) .
6 Operation
CAUTION Never adjust the amplifier to a
very high volume . Permanent
high volumes may damage your
hearing! .
Your ear will get accustomed to high volumes
which do not seem to be that high after some
time . Therefore, do not further increase a high
volume after getting used to it .
1) To prevent an excessive initial volume and any
switching noise, set the controls MIC LEVEL
(4) and AUX LEVEL (6) to zero . Switch on the
amplifier using the POWER switch (7) . The
power LED ON (8) lights up .
2) To make microphone announcements, keep
the talk button (11) pressed and adjust the
volume using the control MIC LEVEL .
Note: If there is feedback during announcements,
in crease the distance between the speaker and the
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®
microphone and / or turn back the volume control
MIC LEVEL .
3) For reproducing music from a unit connected
to the jack AUX (3), use the the control AUX
LEVEL to adjust the volume .
4) To activate the siren, keep the button SIREN
(5) pressed .
Caution! The siren will always sound at max-
imum volume (volume not adjustable) .
5) After operation, switch off the amplifier using
the POWER switch .
7 Specifications
Output power at 4 Ω speaker
Rated power: . . . . . . . . . 10 W
Music power: . . . . . . . . . 15 W
Minimum
speaker impedance: . . . . . 4 Ω
Inputs
Sensitivity/ impedance; connection
1 × MIC: . . . . . . . . . . . . . 3 .4 mV/ 2 .2 kΩ;
1 × AUX: . . . . . . . . . . . . 240 mV/ 11 kΩ; RCA
Frequency range: . . . . . . . 20 – 20 000 Hz
S / N ratio: . . . . . . . . . . . . . 70 dB
THD: . . . . . . . . . . . . . . . . . < 0 .3 %
Power supply: . . . . . . . . . . 12 V (⎓), 2 A
Ambient temperature: . . . 0 – 40 °C
Dimensions (W × H × D): . 151 × 41 × 115 mm
Weight: . . . . . . . . . . . . . . 410 g
Subject to technical modification .
6 .3 mm jack, unbal .
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

17.2970

Table des Matières