Table des Matières
Publicité
HPW 100 EASY
Problem
Motor refuses to
start
Motor stops
Fuses blow
Motor starts but no
pressure
Motor "sounds" but
fails to start
Pressure pulsating
Pressure too low, but
steady Note: Several
types of accessory
will normally deliver
a lower pressure
Motor starts up but
with restricted or no
working pressure
The pressure washer
starts irregularly by
itself
Water leaks from
machine
No detergent taken
in
TROUBLESHOOTING
Possible cause
Plug not connected
Mains socket faulty
Fuse faulty/blown
Extension cable damaged
Motor protector has activated Allow to cool for 15 minutes
Frozen
Fuse faulty/blown
Motor protector has activated Allow to cool for 15 minutes
Wrong mains voltage
Fuses incorrectly rated
Nozzle partly blocked
Insufficient power supply
Voltage loss due to use of
extension cable
Appliance not used for a long
period of time
Problems with TSS (Total
Stop System) device
Air in the inlet water supply
hose/pump
Inadequate water supply
Water filter blocked
Water supply hoses squeezed Straighten out kinked water supply hoses
High pressure hose too long
Nozzle worn
Start/stop valve worn
No water supply
Water filter clogged up
Nozzle clogged up
Pump/spray gun leaky
Leaking pump
Detergent too dense
Residue or restriction in
cleaningagent nozzle
ENGLISH
Solution
Connect plug
Use another socket
Replace fuse
Try without extension cable
Wait for pump/water supply hose/accessory to thaw
Replace fuse
Check that mains voltage corresponds to specifications
on the model tag
Change to a mains supply higher than the pressure
washer amp consumption
Clean nozzle
Check that the voltage of the mains power supply line
is the same as that on the plate
Check characteristics of extension cable
Contact your FF GROUP Service Centre
Contact your FF GROUP Service Centre
Allow power washer to operate with spray-gun trigger
actuated and water cock open, until a uniform operat-
ing pressure is achieved
Check that the water supply corresponds to specifica-
tions. The minimum specification for the water supply
hose is 1/2" or 13 mm diameter
Clean water filter
Remove high-pressure hose extension; max. hose length 7m
Change the nozzle
Quickly actuate trigger 5 times in a row
Connect water supply
Clean the water filter
Clean nozzle
Contact your FF GROUP Service Centre
A slight water leak is permissible; in case of excessive
leak, contact FF GROUP Service Centre
Dilute with water
Flush with clean water and eliminate any restrictions.
If the problem persists, contact your FF GROUP Service
Centre
English |
51
www.ffgroup-tools.com
Publicité
Table des Matières
