HEINE LoupeLight 2 Mode D'emploi page 8

3
Operation
Use the connecting cord cable to connect the LED
light to the mPack mini (note the shape of the plug!).
Use the knob of the mPack mini to switch the
LED light on and adjust the head of the light
vertically such that the examination field is
illuminated centrally.
Jerky, fast movements can alter the
position of the lamp housing.
Turing the swivel lever at the mPack mini allows
continuous adjustment of the brightness.
Fasten the cable on your clothes using
the support clip provided (see Fig. 5).
LoupeLight 2
Adjust the binocular loupe for the intended application. Be sure the eyepieces are
positioned as symmetrically as possible on the optics holder (take off the loupe and
check this), as otherwise the spot of light will appear shifted to the side.
1
MicroLight 2
In order that the MicroLight 2 remains in place in every gradually and freely selectable
position, it may be necessary to retighten the screws using a screwdriver (see Fig. 7).
8/52
2
1
MED 113729
How to fit the LoupeLight 2 to the binocular
loupe mount with i-View
Unscrew the screw (1) on the light mount (2) so
that this can be attached to the round attachment
of the loupe mount (3). The LoupeLight 2 housing
has to fit between the eyepieces (not above
them!).
The cable of the LoupeLight 2 can be affixed on
the right or left side piece of spectacles using the
cable clips. The enclosed coloured retention clips
are designed for personalisation and labelling of
the loupe light.
Fig. 4 Fitting the LoupeLight 2 with i-View
Fig. 5 Cable fastening with
LoupeLight 2 on loupe mount with i-View
If required, a steri-lever (see Fig. 6) can be
attached to one end (1) of the loupe mount
so that the binocular loupe can be swivelled
independently of the light (only HR/HRP
Loupes).
Fig. 6 Using the steri-lever
Fig. 7 Tighten the screws
2020-06-02
(Fig. 4):
®
support clip
®
.
®