Quick TB2 Serie Manuel De L'utilisateur page 14

MAINTENANCE
EN
8
10
9
11
12
5
14
15
16
17
18
19
WARNING: make sure the electrical power to the motor is switched off when working manually on the capstan.
Carefully remove the rope from the drum.
Quick capstans are manufactured with materials resistant to marine environments. In any case, any salt deposits on the out-
®
side must be removed periodically to avoid corrosion and damage to the equipment. The parts where salt may have built up
should be washed thoroughly with fresh water.
Once a year, the drum is to be taken apart as follows:
Use the handle (1) to loosen the bush (2); pull off the drum (3).
Clean all the parts removed to avoid corrosion, and grease the shaft thread (10) (use grease suitable for marine environment).
Remove any oxide deposits from the terminals of the electric motor and the reversing contactor unit; grease them.
14
1
2
13
23
22
21
20
3
4
5
6
4
7
4
6
6
7
27
26
25
24
N. DESCRIPTION
1 STRAIGHT WINDLASS LEVER - NYLON
2 BUSH
3 DRUM
4 BUSH Ø 17
5 OIL SEAL 25X35X7
6 INTERNAL CIRCLIP
7 BEARING
8 KEY 6X6X25 STAINLESS STEEL
9 KEY 6X6X50 STAINLESS STEEL
10 SHAFT TB 500W SERIES
11 TUMBLER BASE
12 BASE INSERT TB Ø105 ANODIZED
13 GASKET/TUMBLER-SHAPED JIG
14 STUDS
15 GEARBOX FLANGE GASKET
TOP TG40
GEARBOX 500W QUICK
16
TG40 SERIES
17 WASHER
18 SPRING WASHER
19 NUT
28
20 NUT
21 MOTORGEARBOX GASKET
22 KEY
23A ELECTRIC MOTOR 500W 12V
23B ELECTRIC MOTOR 500W 12V
24 FLANGE GASKET 500W
25 WATERTIGHT 500W
26 POLES GASKET 500W
27 BOTTOM PROTEC COVER 500W
28 SCREW
TB2 500 - REV003A