Publicité
10. I/O CONFIGURATION AND END OF CYCLE FEEDBACK
During a dispense cycle, an open collector circuit closes and remains closed while the
valve is
dispensing.
Pin 3 and 4 can be as feedback signal to synchronize with other
devices. Power from an external source is allowed to pass through the circuit to
operate a 5 to 24 VDC load. Power consumption must not exceed 250 mA. The load
could be a relay, solenoid, counter, LED, or any device that will operate within a 5 to
24 VDC range and a maximum of 250 mA.
Note:
During the dispense cycle, pin 3 will be grounded. Please make sure the
external device (your machine that controls the dispenser/controller) has the
same ground as the TS500R controller.
Pin 1 (+)
Pin 2 (-)
Pin 3
Pin 4
Pin 5
Pin 6
Pin 5
Pin 7, 8, and 9 = Available
To initiate a dispense cycle with voltage
End of Cycle Feedback
During dispensing cycle, Pin 3 is grounded (-)
End of dispensing cycle,
Pin 3 is not connected (opened)
When low pressure alarm is triggered, Pin 4 is grounded (-)
When low pressure alarm is turned off,
Pin 4 is not connected (opened)
To initiate a dispense cycle with
contact closure
Chasis Ground
14
4.
CARACTERÍSTICAS
Elementos
Descripción
1
Botón de encendido
2
Botón de modo
Botón de
3
configuración/guardar
4
Pantalla
Salida de aire (no
5
regulada)
Regulador de aire a
6
presión
7
Salida de aire (regulada)
5.
INSTRUCCIONES DE INSTALACIÓN
5.1 CONTROL DE LA VÁLVULA NEUMÁTICA
PRECAUCIÓN: Debe instalarse un filtro de 5 micras (TSD800-6) con la unidad para
garantizar un filtrado correcto del aire.
TO AIR SOURCE
10
6
Figura 1.0
Elementos
Descripción
Salida accionada por
8
motor
9
Entrada de aire
10
Bloqueo de cable
Receptáculo del
11
interruptor de pedal
12
Receptáculo de energía
13
Conexión de E/S
14
Salida auxiliar de aire
5
8
4
7
9
3
1
2
Figura 2.0
59
Publicité
Chapitres
