Prior To Initial Start-Up; Starting Up And Temperature Regulation - Electrolux SANTO Notice D'utilisation

Prior to Initial Start–Up
Please clean the appliance interior and all accessories prior to initial
start-up (see section: "Cleaning and Care").

Starting up and temperature regulation

Important! Only use the appliance when built–in!
The temperature regulator is in the
refrigerator compartment on the upper
right. It is also the ON/OFF-switch.
Position „0" = Refrigeration off
Position „1" = Warmest interior tem-
perature
Position „6" = Coldest interior
temperature
1. Plug the mains plug into the mains socket.
2. Set the required temperature by turning the temperature regulator.
The inside light goes on. The compressor starts and then runs automa-
tically.
Note: When the setting is changed, the compressor does not start
immediately if automatic defrosting is currently taking place.
Goods to be refrigerated can be loaded immediately after switching
on, because the storage temperature in the refrigerator is quickly
reached.
Note: From a food science point of view, +5 °C should be considered
cold enough as a storage temperature.
The following effects are of significance in respect of the interior tem-
perature:
– Ambient temperature;
– Quantity and temperature of the food stored;
– Frequency with which the door is opened and how long it is left
open.
– A defect in the appliance.
The temperature regulator setting may therefore need to be adjusted
to suit the specific conditions.
AEG62
31