Storing The Trimmer - GreenWorks Tools 21107 Manuel D'utilisation

EN
FR DE ES
Remove the spool from the cutting head.
NOTE: Remove any old cutting line remaining on the
spool.
Cut a piece of cutting line approximately 3m long.
Insert the cutting line into the anchor hole in the upper
part of the spool. Wind the cutting line around the upper
part of the spool clockwise, as shown by the arrows on
the spool. Place cutting line in the slot on upper spool
flange, leaving about 15cm. extended beyond the slot.
Do not overfill. After winding the cutting line, there
should be at least 0.635 cm between the wound
cutting line and the outside edge of the spool.
Replace the spool, and the spool cover. Refer to spool
replacement earlier in this manual.

STORING THE TRIMMER

Remove the battery pack from the trimmer before
storing.
Problem
String will not advance when using the
auto-feed head.
Grass wraps around shaft housing and
string head.
Motor fails to start when switch trigger is
depressed.
IT PT NL SV DA
Possible cause
String is welded to itself.
Not enough string on spool.
String is worn too short.
String is tangled on spool.
Cutting tall grass at ground level.
Battery is not secure.
Battery is not charged.
Shaft not connected completely.
NO FI HU CS RU
English
Clean all foreign material from the trimmer.
Store it in a place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Store and charge your batteries in a cool area.
Temperatures
temperature will shorten battery pack life.
Never store batteries in a discharged condition. Wait
for battery pack to cool and fully charge immediately.
Store the battery pack where the temperature is below
All batteries gradually lose their charge. The higher the
temperature, the quicker they lose their charge. If you
store your unit for long periods of time without using
it, recharge the batteries every month or two. This
practice will prolong battery pack life.
TROUBLESHOOTING
18
RO PL SL HR ET
above or below
Solution
Lubricate with silicone spray.
Install more string.
replacement earlier in this manual.
Pull string while pressing line release button.
Remove string from spool and rewind. Refer
to string replacement earlier in this manual.
Cut tall grass from the top down to prevent
wrapping.
To secure the battery pack, make sure the
latch on bottom of the battery pack snaps
into place.
Charge the battery pack according to the
instructions included with your model.
Make sure lower shaft is fully seated in shaft
coupler on upper shaft and secure shaft
coupler.
LT LV SK BG
normal room
Refer to string