Storing The Trimmer; Environmental Protection - GreenWorks Tools G40LT Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
SPOOL REPLACEMENT See Figure 10.
Use original manufacturer's replacement cutting line for
best performance.
„ Remove the battery pack.
„ Push in tabs on sides of spool cover.
„ Pull spool cover up to remove.
„ Remove the old spool.
„ To install the new spool, make sure the cutting line is
captured in the slot on the new spool. Make sure the
end of the cutting line is extended approximately 15cm
beyond the slot.
„ Install the new spool so that the cutting line and slot
align with the eyelet in the cutting head. Thread the
cutting line into the eyelet.
„ Pull the cutting line extending from the cutting head so
the cutting line releases from the slot in the spool.
„ Reinstall the spool cover by depressing tabs into slots
and pushing down until spool cover clicks into place.
CUTTING LINE REPLACEMENT See Figures 10-11.
„ Remove the battery pack.
„ Remove the spool from the cutting head.
NOTE: Remove any old cutting line remaining on the
spool.
„ Cut two lines, each being approximately 10 ft. (3 m)
long. Use only .065 in. (1.65 mm) diameter line.
„ Insert one line into the anchor hole in the upper part
of the spool while the other line into the anchor hole in
the bottom part of the spool. Wind the lines clockwise
around the spool simultaneously, as shown by the
arrows on the spool.
„ Replace the spool, and the spool cover. Refer to spool
replacement earlier in this manual.
English (original instructions)

STORING THE TRIMMER

„ Remove the battery pack from the trimmer before
storing.
„ Clean all foreign material from the trimmer.
„ Store it in a place that is inaccessible to children.
„ Keep away from corrosive agents such as garden
chemicals and de-icing salts.
„ Store and charge your batteries in a cool area.
Temperatures
temperature will shorten battery pack life.
„ Never store batteries in a discharged condition. Wait
for battery pack to cool and fully charge immediately.
„ Store the battery pack where the temperature is below
27˚C and away from moisture.
„ All batteries gradually lose their charge. The higher the
temperature, the quicker they lose their charge. If you
store your unit for long periods of time without using
it, recharge the batteries every month or two. This
practice will prolong battery pack life.

ENVIRONMENTAL PROTECTION

„ Environmental protection should be a priority of
considerable importance when using the machine,
for the benefit of both social coexistence and the
environment in which we live. Try not to cause any
disturbance to the surrounding area.
„ Scrupulously comply with local regulations for the
disposal of packaging, deteriorated parts or any
elements with a strong environmental impact; this
waste must not be disposed of as normal waste, it must
be separated and taken to specified waste disposal
centres where the material will be recycled.
„ Scrupulously comply with local regulations for the
disposal of waste materials after mowing.
„ At the time of decommissioning, do not pollute the
environment with the machine, but hand it over to a
disposal centre, in accordance with the local laws in
force.
4
above
or
below
normal
room

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

2101507

Table des Matières