Side Broom Replacement - Nilfisk SW4000 Instructions D'utilisation

ENGLISH

SIDE BROOM REPLACEMENT

WARNING!
It is advisable to wear protective gloves when
replacing the side broom because there can be
sharp debris between the bristles.
1. Drive the machine on a level ground and engage the
parking brake.
2. Turn the ignition key (61) to "0".
3. Lift the side broom with the lever (64).
4. Remove the pin clip (A, Fig. 12), then remove the pin.
5. Remove the broom (B) and recover the protection flange
(C).
6. Install on the hub (D) the new side broom with the
protection flange.
7. Insert the fastening pin and engage its safety clip.
8. Check and adjust the side broom height as shown in the
previous paragraph.
26
INSTRUCTIONS FOR USE
SW4000, FLOORTEC R 870 - 1464809000
D
C
B
Figure 12
A
P100599
03/2013