Operating The Revolving Console; Initial Operation - HASE Merida Mode D'emploi

5. Operating the Revolving Console
The Merida features a revolving console as a standard
feature. To turn the Merida to the desired position, pull the
lever (A) to disengage the locking mechanism. The marking
(B) indicates the middle position for the installation.
The Merida has a maximum rotational angle of 180 degrees;
you can adjust the rotational angle in 15-degree increments.
A
B
fig. 3
WARNING!
Always comply with the safety distances to
combustible and flammable materials!
NOTE!
The revolving function does not work
for stoves with rear-mounted flue pipes
If a floor plate is required, its size must match the rotating
range of the stove. Never turn stove when lighting fire!
max.
max.
max.
fig. 4
fig. 5
fig. 6
6 . Initial Operation
NOTE!
During shipment, condensation moisture can
accumulate in the stove's interior, which may
possibly lead to the appearance of
condensation or water on the stove or flue
pipes. Please dry off these damp areas imme
diately.
The surface of your stove was treated in a sandblasting ma-
chine before applying the colour coating. Despite careful and
thorough inspection, there may still be some residual material
in the stove body, which can fall out when your stove is being
installed.
NOTE!
To prevent any damage, please immediately
vacuum up these small steel pellets with a
vacuum cleaner.
The first time a stove is operated, the heat development causes
the emission of volatile components from the coating, sealing
strips and lubricants, and smoke and odours can occur.
At a higher combustion temperature, this one-time process can
take between 4 to 5 hours. To achieve this higher combustion
temperature, please increase the fuel quantity recommended
in Section 8, „Adding Fuel/ Heating with Nominal Thermal Out-
put", by approximately 25%.
CAUTION!
To prevent adverse effects on health, nobody
should stay in the room(s) during this process
unless absolutely necessary. Make sure the
35