Before Use - Koshin Agro-Mate PGH-50 Mode D'emploi

EN
Please use suction hose for suction side. Please purchase suitable
hose to fit to connection dia and suitable length.
Do not hit, drop or cause any shock to pump as this pump is made
of resin. Do not over tighten suction/delivery flange and plugs.
When screw copper pipe directly, pay attention carefully.
When transporting pump, fuel tap must be off. If not, may cause fire.
Please firmly connect hose with coupling and hose band when
you connect suction or delivery hose to pump.
LABEL-Replace name plate if damaged or peeled, please order with sales store.
*

BEFORE USE

1
Check accessories provided.
List of accessories provided is printed on the pump manual.
2
Fuel / Engine oil
CAUTION For engine operating and notes, please refer "Engine Operation Manual" enclosed.
"Engine oil"
4 stroke engine needs
There is no engine oil in the engine. Before starting engine, engine oil must be filled.
If you start engine without engine oil, engine will burn out and it is difficult to repair.
(Warranty does not cover such claim.)
WARNING Inflammable!! Keep away from fire at all time.
Before starting engine, please check if engine oil is filled to required level.
Without engine oil or shortage of engine oil can be cause of engine troubles.
Please read carefully "Engine Operation Manual" for engine oil instructions.
Inflammable! Do not operate near fire.
Any fuel spillage must be cleaned completely.
Check engine oil before operation. Check and refuel periodically.
Please read "Engine Operation Manual" for instructions.
Stop engine operation when refuel engine oil. Engine oil can be very hot after operation.
Before starting the engine, check if oil gage is tighten enough to avoid oil leak.
"Automotive Unleaded Gasoline"
Please use
Inflammable! Keep away from fire at all time.
Any fuel spillage must be cleaned completely before starting the engine.
Before refueling stop engine and wait until the engine has cooled down.
Do not use old fuel over 30 days. Fuel should be clean and fresh.
Unused fuel in tank (if kept more than 30 days) may cause engine failure.
CAUTION
CAUTION
.
CAUTION
- 4 -
3 How to install Coupling
Suction side
Option
*
Hose nipple *
Coupling *
Nipple
Hose band Suction
*
Coupling packing *
Suction hose *
Delivery side Option
*
Install spare parts in preferred water direction.
Elbow
Coupling packing
*
Hose band
*
Nipple
Hose nipple
*
Coupling
*
Suction hose
*
CAUTION
Roll up the seal tape to attach the nipple or pipe to the suction or delivery sides.
Please install coupling in order of :
If you do not install coupling packing in above order, air leakage may result,
affecting water suction efficiency.
Do not change pump diameter by altering suction hose.
4
Make sure suction hose is connected properly
In case of no self-priming after filling pump with water and engine is started,
check suction hose connection carefully again.
Most cases of no self-priming are caused by improper hose connection.
CAUTION
Use suction hose for suction side. Use couplings/hose band as provided in accessory
and attach hose properly. Installation of strainer at the end of suction hose is necessary.
- 5 -
EN
CAUTION
Make sure to roll up the
seal tape to mark " " on
the nipple.
You need to roll at least
ten times to reach " ".
Suction hose
*
Hose band
*
Coupling
*
*
Hose nipple
*
Coupling packing
*
Delivery
Nipple