Olympia A2250 Mode D'emploi page 24

paper format of the laminating pouch. Place the material to be laminated at the
front edge of the closed end of the laminating pouch.
7.
straight, into the infeed of the laminator. The laminator automatically draws
in the laminating pouches and delivers it on the output side.
If you inadvertently feed the laminating pouch into the laminator at an angle, or
if the rollers are soiled with too much residual adhesive, or if you try to lami-
nate unsuitable materials, laminating pouches can jam inside the laminator.
Use the Jam Release function to clear a pouch jam quickly.
1. Switch the ON/OFF switch to O
2. Disconnect the power plug from the power socket.
3. Press the Jam Release lever on the rear of the machine to the left and
hold it there. This releases the laminating pouch.
C ! Danger of burns due to hot machine surface! During hot
AUTION
laminating, the machine surface heats up. Do not touch the machine
ing until the machine has cooled down before you touch it.
4. Carefully pull the laminating pouch out of the feed side of the laminator.
The laminator must be cleaned following a pouch jam. Clean the laminator as
described in Section
24 L
AMINIERGERÄT
FF
A2250 / A3250
.
.
-