Program Playback - JVC TH-C60 Manuel D'instructions

Advanced operations
Changing the VFP setting
The VFP (Video Fine Processor) function enables
you to adjust the picture character according to
the type of programming, picture tone or
personal preference (except when connecting the TV through
HDMI MONITOR OUT terminal).
7 During playback
1
Press VFP.
The current VFP settings appear on the TV screen.
Example:
2
Press Cursor 3/2 repeatedly to select
the VFP mode.
• NORMAL: Normally select this.
• CINEMA: Suitable for movies.
When you select "NORMAL" or "CINEMA", press VFP to
complete the setting.
• USER 1 and USER 2: You can adjust parameters that affect
picture appearance.
Only when selecting "USER 1" or "USER 2" in step 2, proceed
to perform the following operation;
3
Press Cursor Y/5 repeatedly to select
a parameter you want to adjust.
Adjust gradually and confirm picture appearance results are as
preferred.
• GAMMA: Controls brightness of neutral tints while
maintaining brightness of dark and bright portions.
• BRIGHTNESS: Controls screen brightness.
• CONTRAST: Controls screen contrast.
• SATURATION: Controls screen color depth.
• TINT: Controls screen tint.
• SHARPNESS: Controls screen sharpness.
4
Press ENTER.
Example:
5
Press Cursor Y/5 to change the
setting.
6
Press ENTER.
The current VFP settings appear again.
7
Repeat steps 3 to 6 to adjust other
parameters.
8
Press VFP.
NOTE
• Although the setting display disappears in the middle of the
procedure, the setting at that time will be stored.
• The VFP function is not available when connecting the TV through
HDMI MONITOR OUT terminal.
• "TINT" setting is not effective when connecting the TV through
COMPONENT VIDEO OUT jacks.
See page 23 for button locations.

Program Playback

7 While stopped
1
Press PLAY MODE repeatedly until
program window appears on the TV
screen.
PRG indicator lights on the display window.
2
Follow the instructions that appear on
the TV screen to program the desired
tracks.
• For details on using the number buttons, see "How to use the
number buttons". (See page 22.)
• You can specify the tracks whose number is up to 99.
• Normally the system automatically skips to the Track/
Chapter column after entering the disc number. However,
there may be a case that the number can be entered in the
Title/Group column. In such a case, press 1 (number button)
to proceed to the Track/Chapter column.
• When you press ENTER instead of the number buttons in the
Track/Chapter column, "ALL" appears and all the tracks on
the selected disc are programmed as a step.
To clear the programs one by one from the last entered
number
Press CANCEL repeatedly.
To clear all programs
Press 7.
You can also clear the program by turning off the system.
3
Press 3 (play button).
If all of the programmed tracks have been played back,
playback stops and the program window appears again. Note
that program setting remains.
To check the program contents
During playback, press 7. Playback stops and the program window
appears.
To quit the Program mode
While stopped, press PLAY MODE repeatedly until both program
window and disappear from the TV screen.
NOTE
• The Resume function cannot be used with Program Playback.
• DISC (1-5) on the remote control and DISC (1-5) 3 on the center unit
do not work during Program Playback.
• Program Playback may not work for some discs.
30