Velleman CAMCOLD2 Mode D'emploi page 2

Pan/tilt
Dome size
Dimensions
Weight
Temperature range
4. Installation
The CAMCOLD2 can be column mounted, ceiling mounted or wall mounted. Please follow these instructions to
install the camera:
1) Choose a mounting location. Before mounting the camera make sure the installation area can hold the
weight of the brackets and the pan/tilt.
2) Fix the mounting board.
3) Fix the pan/tilt and the bracket with the screw.
4) Connect the cables as follows:
1.
2.
3.
4.
5.
6.
7.
8.
5) Adjust the handle as follows:
• Move the pan/tilt to the position so that it will begin to move automatically to the right.
• Press the "L" button on the back board.
• Move the pan/tilt to the position so that it will begin to move automatically to the left.
• Press the "R" button on the back board.
• Press the "PAN" button. The pan/tilt will automatically scan between the left and the right.
5) Set the protocol switcher as follows:
Fig. 2
CAMCOLD2
Voltage: 12V DC (not included)
Power consumption: 15W
RS-485 interface
Transfer rate of Pelco-P protocol and RS-485 protocol: 9600 bit/sec
Transfer rate of Pelco-D protocol: 2400 bit/sec
5"
∅150 x 220mm
4kg
Operating temperature 5°C ~ +50°C
Humidity 95%
Power socket
Video signal output
Fuse tube
Power indicator light
Limit-stop adjust
Short circuit pole
RS485 socket
Address code
Fig. 1
2 VELLEMAN