Storage Of The Device - FUXTEC FX-FSR162 Mode D'emploi Original

Original Bedienungsanleitung FUXTEC FX-FSR162_de_en_fr_ita_rev01
WARNING
The spark plug must be screwed down tightly; otherwise, the engine runs hot and is
damaged.
Sharpen the shielded knife
1) Remove cutting knife (E) from protective shield (F).
2. Clamp the knife in a vice. Sharpen the knife with a flat-
file. Please make sure that you keep the angle of the
cutting edge. Only move the sharpening knife in one
direction during the sharpening process.
Fuel filter
In case the tank runs empty, check the fuel filter for
clogging
The easiest way to remove the fuel filter, including the hose from the inside of the tank and
replace or clean it if necessary is to use an Allen key.
35.

Storage of the device

WARNING: Failure to follow these steps may result in carburettor fouling.
That makes later starting difficult and causes permanent damage
1) Perform all general maintenance as described in the maintenance section of
your user manual.
2) Clean the exterior of the device, drive axle, protective shield and nylon cutting head.
3) Drain fuel from the fuel tank.
4) After fuel is drained, start the device.
5) Let the device idle until the device stops by itself. That will clean the carburettor of
fuel.
6) Let the device cool down (about 5 minutes).
7) Use a spark plug wrench, remove the spark plug.
8) Pour one teaspoon of clean 2-stroke oil into the combustion chamber. Pull the starter
rope
slowly several times to coat internal components. Replace the spark plug.
53