FUXTEC FX-FSR162 Mode D'emploi Original page 38

Original Bedienungsanleitung FUXTEC FX-FSR162_de_en_fr_ita_rev01
● Do not use the device if you are tired, sick or under the influence of medication,
drugs or alcohol
● Use an entire nylon cutting head. If you hit a stone or any other obstacle, stop
the device and check the nylon cutting head. A defective or unbalanced nylon
cutting head must never be used
● Before starting, after failure or impact, make sure to check the device and make
sure that it is in good condition
● Caution! Local regulations may limit the use of the device
● Always keep the device with the cutting tool in good condition. Please note that
improper maintenance, the use of non-compliant spare parts or the removal or
modification of safety devices can cause damage to the device and severe injury
to the person working with it
● Secure the device properly during transport to prevent loss of fuel, damage to the
device and injury.
● For devices with a clutch, regularly check that the cutting attachment stops
rotating when the engine is idling
● Check the device before each use for loose fasteners, fuel leaks, damaged parts,
etc. Replace damaged parts before use
● It is necessary to take sufficient breaks
● Do not store the device in an enclosed area where fuel vapours can reach an
open fire from water heaters, stoves, etc. Store the device in a well-ventilated
area only.
● IMPORTANT: When filling fuel, make sure that the device is off and cooled
down. Never refuel when the device is running or hot. If gasoline is spilt, wipe it
up before starting the device
38