Warm Start Of The Device; Stopping The Device; Trimming Techniques; Additional Safety Instructions - FUXTEC FX-FSR162 Mode D'emploi Original

NOTE: If the device does not start after repeated attempts, refer to troubleshooting
chapters.
NOTE: Always pull the starter cord straight out. Pulling the starter at an angle will cause
the rope to rub against the eyelet. Pulling the starter at an angle can cause the starter
cord to fray or break. Always hold the starter handle firmly when the rope pulls back.
Never let the hoist be thrown back from the pulled-out position. This could damage the
starter unit.
30.

Warm start of the device

Place the device on a firm and level surface.
1)
2) Move the engine stop switch to position I
3) Slide the choke to the "WARM START" position
4) Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous fast train will provide a vital spark and start the engine
If the device does not start, please proceed again according to "Cold start of the device
31.

Stopping the device

Unlock the throttle lever. Let the device return to idle. Push the engine stop switch on
the handle upwards until the device stops. If it does not stop, pull out the spark plug
connector in an emergency. Never leave the device unattended while it is running.
32.

Trimming techniques

ADDITIONAL SAFETY INSTRUCTIONS

Before running your device, read the notes in chapters 3 and 4 of this manual.
CAUTION
ALWAYS TRIM AT HIGH ENGINE SPEEDS. Do not let the device run slowly at the
beginning or in trim mode.
ALWAYS MAKE DISTANCE IN WORKING AREAS from cans, bottles, rocks, etc. Whirling
objects can cause serious injury to users or bystanders and damage the device. If an
object is accidentally knocked against, immediately turn OFF the DEVICE and check the
device. Never run the device with damaged or defective parts.
DO NOT use the device for any purpose other than trimming grass.
Original Bedienungsanleitung FUXTEC FX-FSR162_de_en_fr_ita_rev01
48