FUXTEC FX-FSR162 Mode D'emploi Original page 49

Never lift the nylon cutting head above knee height during operation.
Do not run the device on a slope if there is a chance of slipping or losing stability.
Always remember that the tip of the thread will cut. You will get better results if you do
not push into the cutting area. Let the device trim at its
own pace
Hold the device in such a way that the thread head does
not touch the ground and is inclined slightly 20 degrees
to the swing direction.
You can make your work easier by trimming from right
to left
THE NYLON THREAD
CAUTION: Remove grass deposits regularly to prevent overheating of the
drive axle. Grass deposits occur when fibres of the weed become entangled
around the shaft under the protective shield. That prevents the shaft from
cooling properly. Remove grass deposits with a screwdriver or similar tool only when the
device is switched off.
If the device is properly equipped with a protective shield and nylon cutting head, your
device will trim unsightly weeds and large diameter tall grass in areas along fences,
walls, land and around trees.
NOTE: Pay special attention when trimming on brick or stone walls, etc., which will cause
rapid weed wear.
TRIMMING MORE ACCURATELY
Swing the trimmer's nylon cutting head horizontally from side to side. Do not tilt the
nylon cutting head while working. For correct cutting height, trim in advance in a test
area. Keep nylon cutting head at the same level for even depth of cut.
Original Bedienungsanleitung FUXTEC FX-FSR162_de_en_fr_ita_rev01
49