Cleaning The Air Filter; Spark Plug Maintenance - FUXTEC FX-FSR162 Mode D'emploi Original

Original Bedienungsanleitung FUXTEC FX-FSR162_de_en_fr_ita_rev01

Cleaning the air filter

CAUTION: Never run the engine without the air filter.
A dirty air filter puts pressure on engine performance, increases fuel consumption and makes starting more
difficult. If you notice a loss of engine power:
1. Remove the screw on the filter cover and remove the filter.
2. Clean the filter with soap and water. Never use gasoline or benzene!
3. Let the filter dry in the air.
4. Put the filter back in place - fasten the filter cover with the screw.

Spark plug maintenance

To ensure an optimal operation of the engine, the ignition distance of 0.6-0.7mm must be
maintained and must be free of carbon deposits. Always carry out the following steps with the
engine switched off:
1) Carefully remove the spark plug connector. Do not pull at the cable but directly at the
connector (turn slightly left and right to facilitate removal)
2) Use the spark plug wrench supplied to unscrew the spark plug
3) Visually check the spark plug for damage and electrode burn-off,
Remove the carbon deposits
4) Check the gap with a feeler gauge and bend the electrode to the correct distance of 0.6 to
0.7mm
5) Check the spark plug washer and tighten the spark plug with a torque of 9.8-11.8 Nm
6) Mount the ignition cap back on the spark plug
52