FUXTEC FX-FSR162 Mode D'emploi Original page 44

Original Bedienungsanleitung FUXTEC FX-FSR162_de_en_fr_ita_rev01
1. Use the butterflyscrew and the non-slip nut to connect individual elements.
2.Insert the butterflyscrew through the guide hole provided in the pole as shown. The
end of the butterflyscrew fits into the curved surface of the rod.
3.Screw the nut onto the bolt first and then adjust the iron piece level.
4. then turn the wing screw by hand to the right until the plane of the screw matches
the iron surface and tighten it without loosening it.
5.Make sure that the plane of the wing screw is tight against the iron surface and is not
loose. Follow installation steps 1-4 and install the other 2 places in order.
44